Wool. The designer must verify that fabric content,
pattern, and color specified are not proprietary and
that several manufacturers can provide a similar
product to that specified.
Filler trim incurs added cost and should be omitted
unless it is desired for aesthetic reasons.
**************************************************************************
a. The panels shall be available in the following options:
[acoustical,] [non-acoustical,] [safety glazed,] [open frame] [_____].
Exposed panel trim shall have a [factory baked enamel or epoxy powder]
[wood,] finish. [Filler trim shall either match the panel trim or be
fabric covered to match the panel fabric.] [Filler trim shall not be
provided.] Each fabric-faced panel shall have a seamless width of
fabric stretched over the entire face of the panel and the color of
each fabric utilized shall be consistent throughout the installation.
Curved panels may use adhesives on curved sections. The fabric shall
be attached securely and continuously along the entire perimeter of the
panel and shall allow for easy removal and replacement in the field
(with the exception of curved panels). Fabric shall be factory
installed and panel fabric content shall be [_____].
b. The stacking panel-frames shall accommodate covers which are
available in the following options: [safety glazed,] [acoustical,]
[open pass through frames,] [wood veneer,] [upholstered,]
[laminate/vinyl,] [cable access channels,] [rail organizer,] [marker
surface,] [tackable surface,] [work tools accommodation,] [_____].
[Frame covers may have different options on either side of the frame.]
Exposed panel trim shall have a [factory baked enamel or epoxy powder]
[wood] finish. [Filler trim shall either match the panel trim or be
fabric covered to match the panel fabric.] [Filler trim shall not be
provided.] Each upholstered frame cover shall have a seamless width of
fabric stretched over the entire face of the cover, and the color of
each fabric used shall be consistent throughout the installation. The
fabric shall be attached securely and continuously along the entire
perimeter of the cover and shall allow for easy removal and replacement
in the field. Fabric shall be factory installed and panel fabric
content shall be [_____].
c. The spine wall frames shall accommodate covers which are available
in the following options: [safety glazed,] [painted] [acoustical]
[wood veneer] [upholstered] [laminate/vinyl] [tackable surface] [marker
surface] [paper management] [vertical storage] [cable access] [_____].
Frame covers may have different options on either side of the frame.
Exposed trim shall have a [factory baked enamel or epoxy powder] [wood]
[metal] finish. Spine wall covers must be easily removable even while
panels and workstation components are attached. Each fabric-faced
frame cover shall have a seamless width of fabric stretched over the
entire face of the cover, and the color of each fabric used shall be
consistent throughout the installation. The fabric shall be attached
securely and continuously along the entire perimeter of the cover and
shall allow for easy removal and replacement in the field. Fabric
shall be factory installed and have a content of [_____].
2.2.6
Raceways
Raceways shall be an integral part of the panel and spine wall. Panels and
spine walls, whether powered or nonpowered, shall be provided with a
SECTION 12705
Page 14
Previous Page
