DIVISION 3: INTERIOR CONCRETE PAINT TABLE
System DFT: 4 mils 100 microns
Note: Primer may be reduced for penetration per manufacturer's
instructions.]
D.
[New and uncoated existing] [and Existing, previously painted] concrete
walls and bottom of swimming pools:
1. [Chlorinated Rubber
Primer:
Intermediate:
Topcoat:
SSPC Paint 18
SSPC Paint 18
SSPC Paint 18
System DFT: Per Manufacturer
Note: Primer may be reduced for penetration per manufacturer's
instructions.]
2. [Epoxy
New; MPI INT 3.1F /
Existing; MPI RIN 3.1E
Primer:
Intermediate:
Topcoat:
MPI 77
MPI 77
MPI 77
System DFT: 4 mils
100 microns
Note: Primer may be reduced for penetration per manufacturer's
instructions.]
E.
[[New and uncoated existing] [and Existing, previously painted] concrete
floors in following areas [
]:
1. [Latex Floor Paint
New; MPI INT 3.2A-G2 (Flat) / Existing; MPI RIN 3.2A-G2 (Flat)
Primer:
Intermediate:
Topcoat:
MPI 60
MPI 60
MPI 60
System DFT: 5 mils 125 microns]
2. [Alkyd Floor Paint
New; MPI INT 3.2B-G2 (Flat) / Existing; MPI RIN 3.2B-G2 (Flat)
Primer:
Intermediate:
Topcoat:
MPI 59
MPI 59
MPI 59
System DFT: 5 mils 125 microns]
3. [Epoxy
New; MPI INT 3.2C-G6 (Gloss) / Existing; MPI RIN 3.2C-G6 (Gloss)
Primer:
Intermediate:
Topcoat:
MPI 77
MPI 77
MPI 77
System DFT: 5 mils 125 microns]
Note: Primer may be reduced for penetration per manufacturer's
instructions.]
**************************************************************************
NOTE: (Division 4: Interior Concrete Masonry Units
Paint Table).
Use MPI 4 or MPI 116 block filler if smooth surface
is required on CMU surfaces.
(Substrate C).
List other high humidity areas
SECTION 09900
Page 58
Previous Page
