f.
Changes or modifications which result from the final inspection.
g. Where contract drawings or specifications present options, only
the option selected for construction shall be shown on the final as-built
prints.
h. If borrow material for this project is from sources on Government
property, or if Government property is used as a spoil area, the Contractor
shall furnish a contour map of the final borrow pit/spoil area elevations.
i. Systems designed or enhanced by the Contractor, such as HVAC
controls, fire alarm, fire sprinkler, and irrigation systems.
j. Modifications (change order price shall include the Contractor's
cost to change working and final as-built drawings to reflect
modifications) and compliance with the following procedures.
(1) Directions in the modification for posting descriptive
changes shall be followed.
(2) A Modification Circle shall be placed at the location of each
deletion.
(3) For new details or sections which are added to a drawing, a
Modification Circle shall be placed by the detail or section title.
(4) For minor changes, a Modification Circle shall be placed by
the area changed on the drawing (each location).
(5) For major changes to a drawing, a Modification Circle shall
be placed by the title of the affected plan, section, or detail at
each location.
(6) For changes to schedules or drawings, a Modification Circle
shall be placed either by the schedule heading or by the change in
the schedule.
(7) The Modification Circle size shall be 12.7 mm 1/2 inch
diameter unless the area where the circle is to be placed is
crowded. Smaller size circle shall be used for crowded areas.
1.2.1.3
Drawing Preparation
The as-built drawings shall be modified as may be necessary to correctly
show the features of the project as it has been constructed by bringing the
contract set into agreement with approved working as-built prints, and
adding such additional drawings as may be necessary. These working
as-built marked prints shall be neat, legible and accurate. These drawings
are part of the permanent records of this project and shall be returned to
the Contracting Officer after approval by the Government. Any drawings
damaged or lost by the Contractor shall be satisfactorily replaced by the
Contractor at no expense to the Government.
1.2.1.4
Computer Aided Design and Drafting (CADD) Drawings
**************************************************************************
NOTE: Edit this paragraph to specify CADD drawings
compatible with the costumer's CADD system,
SECTION 01780A
Page 6
Previous Page
