e.
Component details
f.
Throat tile details
1.3.2.4
Dampers, Stacks, and Breechings
Submit drawings showing the following:
a.
General arrangement
b.
Breeching and reinforcing details
c.
Breeching hangers and support details
d.
Dampers and operators
e.
Access doors and frames
f.
Expansion joints
g.
Stack details
For stack details, include anchor bolt and foundation details, stack
sampling ports, platforms, and accessories.
1.3.2.5
Fuel Oil Equipment
Drawings may be manufacturer's standard size for pumps, pump curves,
valves, strainers manufacturer's standard size for pumps, pump curves,
valves, strainers and pump wiring. Submit drawings showing the following:
a.
Certified outline and general arrangement
b.
Certified pump curves
c.
Equipment detail sheets including viscosity controller, heater,
valves
d.
Electrical wiring diagrams
e.
Oil tanks, foundations, tank heaters, appurtenances, water
drawoff, level indication
1.3.2.6
Piping and Specialty Items
Drawings may be manufacturer's standard size.
Submit drawings showing the
following:
a.
Details of special valves and fittings
b.
Feedwater regulator details and schematics
c.
Details and schematics of feedwater automatic recirculation
1.3.2.7
Ball Joint Installation Details
Include allowable angular flex and minimum offset dimensions for approval.
SECTION 15511N
Page 20
Previous Page
