(13) Steam temperature:
[_____] degrees C F
(14) Heater type:
[Bare Tube] [Extended Surface]
b.
Fuel Oil Heater Set With Electric Startup Heater
(1)
Oil temperature at inlet of heater:
[_____] degrees C F
(2)
Oil temperature at outlet of heater:
[_____] degrees C F
(3)
Maximum oil pressure drop through heater:
[_____] kpa psi
(4)
Capacity of heater:
[_____] L/s gpm
(5)
Heating power supply at three phase, 60 Hz:
[_____] volts
(6)
Control power supply 120 volts, single phase, 60 Hz.
1.3.1.7
Deaerating Heater
a.
Design pressure:
207 kpa (gage) 30 psig
b.
Normal steam operating pressure:
[_____] kPa (gage) psig
c.
Maximum steam operating pressure:
[_____] kPa (gage) psig
d.
Capacity (minimum):
[_____] kg/sec lb/hr of feedwater
e.
Inlet Conditions at Heater:
Maximum
Pressure
Temp. Range
Flow Rate
kPa (gage)
Degrees C
kg/s
(1)
Condensate return
[_____]
[_____ to _____]
[_____]
(2)
[_____]
[_____ to _____]
[_____]
trap returns
(3)
Makeup water
[_____]
[_____ to _____]
[_____]
(softened)
Maximum
Pressure
Temp. Range
Flow Rate
psig
Degrees F
lb/hr
(1)
Condensate return
[_____]
[_____ to _____]
[_____]
(2)
[_____]
[_____ to _____]
[_____]
trap returns
(3)
Makeup water
[_____]
[_____ to _____]
[_____]
(softened)
f.
Outlet temperature of feedwater from heater at design capacity:
[_____] degrees C F
g.
Heating steam pressure:
[_____] kPa (gage) psig
SECTION 15511N
Page 18
Previous Page
