b.
Oil temperature at outlet of heater:
[_____] degrees C F
c.
Maximum oil pressure drop through heater:
[_____] kPa psi
d.
Capacity of heater:
[_____] L/s gpm
e.
Heating power supply at three phase, 60 Hz:
[_____] volts
f.
Control power supply 120 volts, single phase, 60 Hz
1.4.1.9
Ash Handling System (Pneumatic)
a.
Capacity:
(1) Ash Handling System: Estimated capacities at maximum plant
output are listed below; ash handling system capacity shall be
sized for twice the amounts listed.
[_____] Mg tons per hour for fly ash
[_____] Mg tons per hour for bottom ash at the farthest ash intake
from the exhauster
[_____] Mg tons per hour in main ash line leaving the boiler house
(minimum).
(2) Ash silo: Storage capacity of ash silo is specified in the
paragraph entitled "Ash Storage Silo."
(3)
Rotary unloader:
[_____] Mg tons per hour
b.
General Data
(1)
Available water pressure:
[_____] kPa (gage) psig
(2)
Available air pressure:
[_____] kPa (gage) psig
(3)
Seismic Zone:
[_____]
(4)
Wind Velocity (Gusts):
[_____] km/hr mph
(5)
Altitude of plant:
[_____] m ft
(6)
Steam rating of plant:
[_____] kg/sec lb/hr
(a)
Maximum continuous rating of boiler No. 1 [_____] kg/sec lb/hr
(b)
Maximum continuous rating of boiler No. 2 [_____] kg/sec lb/hr
[(c) Maximum continuous rating of boiler No. 3 [_____] kg/sec
lb/hr]
[(d) Maximum continuous rating of boiler No. 4 [_____] kg/sec
lb/hr]
(7)
Coal Analysis
(a)
Ash:
[_____] percent
SECTION 15501N
Page 25
Previous Page
