(1)
Number of assemblies:
[_____]
(2)
Tag numbers:
As Indicated
(3)
Capacity:
1.60 L/s 25 gpm at 450 ssu
(4)
Suction lift required:
[_____] kPa ft of water
(5)
Discharge pressure:
[_____] kPa (gage) psig
(6) Operating temperature:
[49] [_____] degrees C [120] [_____]
degrees F
(7)
Viscosity range:
[450 to 3000] [_____ to _____] ssu
(8)
Specific gravity:
[.92 to .99] [_____ to _____]
(9)
Viscosity at brake power selection point:
[5000] [_____] ssu
(10) Maximum pump speed:
1750 rpm
(11) Motor kW hp:
[_____]
(12) Fuel oil:
No. [6, low sulfur] [_____]
1.4.1.7
[Fuel Oil Pump and Heater Set
a.
Capacity each pump and each steam heater:
[_____] L/s gpm
b.
Suction lift:
[_____] kPa ft of water
c.
Discharge pressure at outlet of heater:
[_____] kPa (gage) psig
d.
Maximum pump speed:
1750 rpm
e.
Specific gravity range:
[.92 to .99] [_____ to _____]
f.
Viscosity at brake power selection point:
5000
ssu
g.
Viscosity range:
[500 to 5000] [_____ to _____] ssu
h.
Oil temperature at inlet of heater:
[_____] degrees C F
i.
Oil temperature at outlet of heater:
[_____] degrees C F
j.
Maximum oil pressure drop through heater:
[_____] kPa psi
k.
Heating medium:
Steam
l.
Steam pressure available:
[_____] kPa (gage) psig
m.
Steam temperature:
[_____] degrees C F
n.
Heater type:
[Bare Tube] [Extended Surface]]
1.4.1.8
Electric Startup Heater
a.
Oil temperature at inlet of heater:
[_____] degrees C F
SECTION 15501N
Page 24
Previous Page
