Maximum:
[_____] kg/sec lb/hr
Minimum:
[_____] kg/sec lb/hr
(3)
Required net available draft at stack inlet
At maximum gas flow:
[_____] Pa inches water
(4) Gas exit velocity (cone exit)
Maximum at maximum conditions:
[_____] m/sec ft/sec
(5)
Flue gas acid dew point
Coal:
[_____] degrees C F
Fuel oil:
[_____] degrees C F
(6)
Test pressures
Shop test:
[_____] Pa inches water
(7)
Thermal efficiency of stack:
96 to 98 percent
(8) Stack friction, max. @ design condition:
[_____] Pa inches
water
(9)
Stack height
Ground elevation:
[_____] m ft
Roof elevation:
[_____] m ft
Stack height:
[_____] m ft
Foundation or footing elevation:
[_____] m ft
(10)
Wind pressure:
[_____] kg/m2 psf
(11)
Wind velocity, gusting:
[_____] km/hr mph
(12)
Stack Diameter, min. (below exit cone):
[_____] mm inches
(13) Max. stack deflection (from vertical center line):
[_____]
mm inches
(14) Soil bearing stress, maximum:
[_____] kg/m2 psf
(15) Seismic zone:
[_____]
1.4.1.6
Fuel Oil Pump
**************************************************************************
NOTE: The values enclosed in brackets are for No. 6
low sulfur fuel oil. Adjust values to suit fuel oil
used if other than No. 6.
Tabulated pump data is included in the
specifications but it is preferred that such
SECTION 15501N
Page 22
Previous Page
