**************************************************************************
NOTE: Edit Table A to select only the optional
safety controls required for the project.
**************************************************************************
t.
Optional safety controls required:
As specified on Table A.
TABLE A.
OPTIONAL SAFETY CONTROLS
Type I
Type II
Type III
Shut
Shut
Shut
Alarm Down
Alarm Down
Alarm Down
_____ ____
_____ ____
_____ ____
High-lubrication oil temp.
-
-
x
x
x
x
Cylinder lubrication failure
-
-
-
x
-
-
High main bearing temperature
-
x
-
x
-
x
High discharge-air temperature
x
x
x
x
x
x
High discharge-air pressure
x
x
x
x
x
x
High intercooler air temp.
x
x
x
x
-
-
Low cooling water flow
-
x
-
x
-
-
Low water pressure
-
x
-
x
-
-
High water temperature
x
x
x
x
-
-
High intercooler moisture
x
x
x
x
-
-
separator level (two-stage
compressors only)
Excessively high motor temp.
x
-
x
-
x
-
Excessive vibration
-
x
-
x
-
-
u.
Gages and visual I.D. lights mounting (optional controls):
[Panel-mounted.] [Mounted on separate console.]
[Not applicable.]
v.
Aftercooler: Required; [Water-cooled, shell-and-tube type] [or]
[air-cooled, tube-and-fin type]. A centrifugal moisture separator
is also required.
w.
Air receiver:
[Required] [Not required].
x.
Receiver volume: [As specified in FS XX-C-2816.] [As indicated.]
[[_____] liter gal.] [[_____] cu. meter ft.] [Not applicable.]
y.
Receiver mounting stand:
[Required] [Not required]
[Not
applicable].
Position of receiver:
[Horizontal] [Vertical].
z.
Compressor and motor: [Required] [Not required]. To be mounted on
receiver: [Not applicable].
aa.
Compressor housing (III units):
[Not applicable]
[Required].
bb.
Motor:
As specified in FS XX-C-2816.
cc.
Electrical power supply characteristics:
As indicated.
dd.
Motors 93 kW 125 hp and larger to be synchronous: [Required] [Not
required] [Not applicable].
SECTION 15211N
Page 14
Previous Page
