2.2.4
Nameplate
Metal, securely fastened to equipment or base, listing:
Manufacturer's name and address
Model and serial numbers
Compressor operating data and rating.
2.2.5
Receiver
ASME BPVC SEC VIII D1 and ASME BPVC SEC IX stamp. Provide service valve,
pressure gage, and ASME BPVC SEC VIII D1 and ASME BPVC SEC IX code safety
valve.
2.2.6
Receiver Condensate Drain
Automatic float-type trap per FS A-A-60001.
2.2.7
Compressor Accessories
Air inlet filter and silencer. Air-cooled intercooler and aftercooler
which reduce air discharge temperature to 38 degrees C 100 degrees F.
2.2.8
Control
Unloaded start with enclosed diaphragm-type pressure switch automatically
controlling start-and-stop.
2.2.9
Motor
Squirrel-cage induction motor with drip-proof enclosure and conforming with
NEMA MG 1, suitable for operation on the indicated power supply. Rated
horsepower of motor shall equal or exceed power required for continuous
operation of compressor at full load.
2.2.10
Starter
Capacity and electrical characteristics shall be compatible with motor.
Starter shall conform with NEMA ICS 2 with NEMA ICS 6 enclosure. Include
thermal overload protection of all phases.
2.2.11
Noise
84 dBA maximum sound level one meter from compressor unit.
2.3
LOW PRESSURE AIR RECEIVER
ASME BPVC SEC VIII D1, labeled and rated for [862] [1379] kPa (gage) [125]
[200] psig, equipped with required valves and trimmings, including gage and
automatic drain valve and ASME BPVC SEC VIII D1 and ASME BPVC SEC IX
pressure safety relief valve. Pressure as indicated. [Sandblast exterior
and interior to SSPC SP 10, near-white. Lining shall be a factory applied
0.20 mm 8 mil minimum white epoxy coating.] Exterior finish shall be
[standard factory finish] [two coats of rust inhibitor primer and one coat
epoxy enamel].
SECTION 15211N
Page 16
Previous Page
