shredders, etc., with a minimum operation of 2,000 hr per year of
service with a minimum of 2 years of qualifying service. The
certification of the unit's speed, horsepower, and duty rating
that forms the basis of the qualifying experience is required for
acceptance and shall be within 30 percent of [this drive's rating]
[these drives' ratings].
Welder Qualifications[; G][; G, [_____]]
Submit a letter listing the welder-qualifying procedures for
each welder, complete with all supporting data such as test
procedures used, what was tested to, and a list of the names of
all welders and their identification symbols.
Installation[; G][; G, [_____]]
Submit a copy of the manufacturer's installation and alignment
procedures, including a detailed description of the manufacturer's
recommended break-in procedure.
SD-06 Test Reports
Engine[; G][; G, [_____]]
Submit a fully documented shop test report.
Submit the field test report, documenting all data for
lubrication oil temperature and flow, cooling [water] [air]
temperature and flow, and compliance with specified performance
criteria tested during the field tests.
SD-07 Certificates
Pressure Vessels[; G][; G, [_____]]
Submit certificates of compliance for pressure vessels including
official, signed statements from the fabricators of heat
exchangers and expansion tanks associated with the engine cooling
system certifying compliance with ASME BPVC SEC VIII D1.
Regulatory Requirements[; G][; G, [_____]]
Submit certificates of compliance for equipment and installation
including official, signed statements from manufacturers and
installation contractors. The statements shall certify the item
and quantity supplied and either the date of shipment or
installation.
SD-10 Operation and Maintenance Data
[Diesel] [Natural Gas Fueled] Engine[; G][; G, [_____]]
Submit an Operation and Maintenance Manual detailing start-up
and operating procedures, lubrication instructions, installation
and alignment procedures, routine maintenance requirements and
procedures, complete detailed procedures for disassembly and
reassembly of the engine, parts list for all parts detailed,
assembly plans of the engine showing all parts, suppliers for all
parts, settings and adjustment for protective devices, and a list
SECTION 15133A
Page 12
Previous Page
