SOCIETY OF AUTOMOTIVE ENGINEERS INTERNATIONAL (SAE)
SAE ARP892
(1965; R 1994) DC Starter-Generator, Engine
SAE J1995
(1995) Engine Power Test Code - Spark
Ignition and Compression Ignition - Gross
Power Rating
SAE J537
(2000) Storage Batteries
UNDERWRITERS LABORATORIES (UL)
UL 1236
(2002) Battery Chargers for Charging
Engine-Starter Batteries
1.2
SYSTEM DESCRIPTION
1.2.1
General Requirements
[The] [Each] engine shall be provided and installed complete and totally
functional, with all necessary ancillary equipment including, but not
limited to, air filtration, starting system, instrumentation, lubrication,
fuel system, cooling system, and engine exhaust system. [The] [Each]
engine rating shall be in accordance with SAE J1995. The [diesel] [natural
gas fueled] engine pump drives shall be complete units with all components,
accessories, and system interconnections coordinated, so that the complete
assembly shall have the capabilities required, for proper operation with
the pump specified under Section 15131A VERTICAL PUMPS, AXIAL-FLOW AND
MIXED-FLOW IMPELLER-TYPE and the speed reducer specified in Section 15005A
SPEED REDUCERS FOR STORM WATER PUMPS.
1.2.2
Performance Requirements
**************************************************************************
NOTE: The designer should specify the service
requirements for the pump drive: Continuous,
Standby, or Emergency. The designer should furnish
pump manufacturer's data including pump curves and
plans unless this specification is used in
conjunction with pump specification UFGS-15131A as a
package. The selection of the engine speed should
follow the guidance given in EM 1110-2-3105. Rated
capacity should be based on the pump manufacturer's
recommendation.
**************************************************************************
Service Requirements:
[Continuous][Standby][Emergency]
Rated Capacity:
[110 percent maximum kW (HP)
required from the pump curves at
specified speed plus power required
by the accessories]
Overload Capacity:
[110 percent rated capacity for
2 hr in 24 consecutive hrs]
Maximum Speed:
[_____][900][1,200][1,800] RPM
[Characteristics of the pump load for the engine drive are
SECTION 15133A
Page 7
Previous Page
