1.8.4.1
Minor Inspections
console equipment, peripheral equipment, local processors, sensors, and
electrical and mechanical controls. Minor inspections shall also include
mechanical adjustment of laser printers.
1.8.4.2
Major Inspections
Major inspections shall include work described under paragraph Minor
Inspections and the following work:
a.
Clean interior and exterior surfaces of all system equipment and
local processors, including workstation monitors, keyboards, and
console equipment.
b.
Perform diagnostics on all equipment.
c.
Check, walk test, and calibrate each sensor.
d.
Run all system software diagnostics and correct all diagnosed
problems.
e.
Resolve any previous outstanding problems.
f.
Purge and compress data bases.
g.
Review network configuration.
1.8.4.3
Scheduled Work
Scheduled work shall be performed during regular working hours, Monday
through Friday, excluding federal holidays.
1.8.5
Emergency Service
**************************************************************************
NOTE: In some cases the designer may determine a
less rapid response time is acceptable when weighed
against the cost of the service. The designer must
insert a time based upon input from the user.
**************************************************************************
The Government will initiate service calls when the system is not
functioning properly. Qualified personnel shall be available to provide
service to the complete system. The Government shall be furnished with a
telephone number where the service supervisor can be reached at all times.
Service personnel shall be at site within [2] [4] [_____] hours after
receiving a request for service. The system shall be restored to proper
operating condition within 8 hours after service personnel arrive onsite
and obtain access to the system.
1.8.6
Operation
Performance verification test procedures shall be used after all scheduled
operation.
SECTION 13720A
Page 29