Rubber sheet flooring shall conform to [ASTM F 1859 (flooring without
backing), [Type I homogeneous] [Type II layered]] [or] [ASTM F 1860
(flooring with backing), [Type I homogeneous] [Type II layered]], [minimum]
[1 m 36 inches] [_____] wide. Surface shall be [smooth] [embossed]
[_____]. Overall thickness shall be [2] [2.5] [3] [_____] mm [0.080]
[0.100] [0.118] [_____]inch thick.
2.5
SOLID VINYL TILE [TYPE [A] [_____]]
Solid vinyl tile shall conform to ASTM F 1700 [Class I monolithic (minimum
wear layer thickness 3.2 mm 0.125 inches and minimum overall thickness 3.2
mm 0.125 inches] [Class III printed film (minimum wear layer thickness 0.50
mm 0.020 inches and minimum overall thickness 3.2 mm 0.125 inches)], Type
[A (smooth)] [B (embossed)]. Tile shall be [300] [400] [450] [600] [900]
[_____] mm [12] [16] [18] [24] [36] [_____] inches square.
2.6
SHEET LINOLEUM [TYPE [A] [_____]]
Linoleum shall conform to ASTM F 2034 and consist of a homogeneous layer of
a mixture of linoleum cement (binder in linoleum consisting of a mixture of
linseed oil, pine rosin, fossil, or other resins or rosins, or an
equivalent oxidized oleoresinous binder), cork and/or wood flour, mineral
fillers, and pigments bonded to a jute backing. Linoleum shall not be less
than 1800 mm 6 feet wide and overall thickness shall not be less than [2.0
mm 0.080 inches] [2.5 mm 0.100 inches] [3.2 mm 0.125 inches]. As required,
provide welding rods as recommended by the manufacturer for heat welding of
joints.
2.7
LINOLEUM TILE [TYPE [A] [_____]]
Linoleum tile shall conform to ASTM F 2195 and consist of a homogeneous
layer of a mixture of linoleum cement (binder in linoleum consisting of a
mixture of linseed oil, pine rosin, fossil, or other resins or rosins, or
an equivalent oxidized oleoresinous binder), cork and/or wood flour,
mineral fillers, and pigments bonded to a [jute] [_____] backing.
Linoleum tile shall not be less than [450 mm 18 inches] [_____] square and
overall thickness shall not be less than [2.5 mm 0.100 inches] [_____].
2.8
WALL BASE
**************************************************************************
NOTE: Job formed corners are recommended. The
return on preformed corners is not always long
enough to hold the piece in place and the corners
can be knocked off during vacuuming and other
cleaning operations.
Base is available in different lengths ranging from
1220 mm (4 feet) pieces to 30480 mm (100 feet) or
36576 mm (120 feet) rolls. Availability and roll
lengths vary dependent on manufacturer. Identify
required length if it impacts design intent. Some
manufacturers of Type TS (vulcanized thermoset
rubber) base offer only 1220 mm (4 feet) lengths and
not roll goods.
**************************************************************************
Base shall conform to ASTM F 1861, [[Type TS (vulcanized thermoset rubber)]
[or] [Type TP (thermoplastic rubber)]] [, or] [Type TV (thermoplastic
SECTION 09650
Page 11
Previous Page
