2.13
ADHESIVES
**************************************************************************
NOTE: Conformance with South Coast Air Quality
Management District (SCAQMD) Rule #1168 as noted
complies with LEED and SPiRit requirements.
**************************************************************************
Adhesives for flooring, base and accessories shall be as recommended by the
manufacturer and comply with local indoor air quality standards.[ VOC
content must be less than the current VOC content limits of SCAQMD Rule
#1168.]
2.14
SURFACE PREPARATION MATERIALS
**************************************************************************
NOTE: Particleboard is not recommended for use as
an underlayment. Panel type underlayments, such as
plywood and hardboard, are specified in Sections
06100N and 06100A ROUGH CARPENTRY. Coordinate
underlayments requirements with the ROUGH CARPENTRY
specifications.
**************************************************************************
Surface preparation materials, such as panel type underlayment, lining
felt, and floor crack fillers shall be as recommended by the flooring
manufacturer for the subfloor conditions. Panel type underlayment products
shall comply with ASTM F 1482.
2.15
POLISH/FINISH
Polish shall be as recommended by the manufacturer and conform to ASTM D
4078.
2.16
CAULKING AND SEALANTS
Caulking and sealants shall be in accordance with Section 07920 JOINT
SEALANTS.
2.17
MANUFACTURER'S COLOR, PATTERN AND TEXTURE
**************************************************************************
NOTE: Editing of color reference sentence(s) shall
be coordinated with the Government. Generally the
09915 COLOR SCHEDULE or drawings are used when the
project is designed by an Architect or Interior
designer. Color shall be selected from
manufacturers standard colors or identified in this
specification only when the project has minimal
When the government directs that color be located in
the drawings, a note will be added that states:
"Where color is shown as being specific to one
manufacturer, an equivalent color by another
manufacturer may be submitted for approval.
Manufacturers and materials specified are not
intended to limit the selection of equal colors from
SECTION 09650
Page 13
Previous Page
