3.1.7
Monitors
The Contractor shall install the monitors as shown and specified; connect
all signal inputs and outputs as shown and specified; terminate video input
signals as required; and connect the monitor to AC power.
3.1.8
Switcher
The Contractor shall install the switcher as shown and according to
manufacturer's instructions; connect all subassemblies as specified by the
manufacturer and as shown; connect video signal inputs and outputs as shown
and specified; terminate video inputs as required; connect alarm signal
inputs and outputs as shown and specified; connect control signal inputs
and outputs for ancillary equipment or secondary control/monitoring sites
as specified by the manufacturer and as shown; connect the switcher CPU and
switcher subassemblies to AC power; load all software as specified and
required for an operational CCTV system configured for the site
requirements, including data bases, operational parameters, and system,
command, and application programs; provide the original and 2 backup copies
for all accepted software upon successful completion of the endurance test;
and program the video annotation for each camera.
3.1.9
Video Recording Equipment
The Contractor shall install the video recording equipment as shown and as
specified by the manufacturer; connect video signal inputs and outputs as
shown and specified; connect alarm signal inputs and outputs as shown and
specified; and connect video recording equipment to AC power.
3.1.10
Video Signal Equipment
The Contractor shall install the video signal equipment as specified by the
manufacturer and as shown; connect video or signal inputs and outputs as
shown and specified; terminate video inputs as required; connect alarm
signal inputs and outputs as required; connect control signal inputs and
outputs as required; and connect electrically powered equipment to AC power.
3.1.11
Camera Housings, Mounts, and Poles
**************************************************************************
NOTE: Designer will specify correct Section numbers
for concrete camera pole foundations, electrical
work, and control signal cable.
**************************************************************************
The Contractor shall install the camera housings and mounts as specified by
the manufacturer and as shown, provide mounting hardware sized
appropriately to secure each camera, housing and mount with maximum wind
and ice loading encountered at the site; provide a foundation for each
camera pole as specified and shown; provide a ground rod for each camera
pole and connect the camera pole to the ground rod as specified in Section
[_____]; provide electrical and signal transmission cabling to the mount
location as specified in Section [_____]; connect signal lines and AC power
to mount interfaces; and connect pole wiring harness to camera.
3.2
SYSTEM STARTUP
The Contractor shall not apply power to the CCTV system until the following
items have been completed:
SECTION 16751A
Page 40
Previous Page
