between the pole base and the camera mount. The wiring harness shall be
compatible with the model camera to be mounted on the pole and the video
DTM. Surge protection shall be provided at the pole between the wiring
harness, and the incoming electronic signal lines and AC power line. The
pole shall have a weatherproof, AC power service outlet that is surge
protected and has a ground fault interruption device. Separate circuit
breakers shall be provided for camera AC power and service outlet AC power.
2.14.2
Straight Camera Pole
The camera mounting pole shall be a [non-hinged] [hinged] straight aluminum
pole with [counterweights] [and] mounting base. All fittings shall be
stainless steel. The camera mounting plate shall locate the camera 4.6 m
180 inches vertically from the base, and 508.0 mm 20 inches horizontally
from the centerline of the pole to the centerline of the camera. The
camera mount shall be adjustable with a minimum of 40 degrees pan away from
the pole and 6 degrees pan toward the pole, and plus and minus 90 degrees
of tilt. The pole shall have an internal wiring harness that routes
[video,] [video, sync,] and power between the pole base and the camera
mount. The wiring harness shall be compatible with the camera to be
mounted on the pole and the video DTM. Surge protection shall be provided
at the pole between the wiring harness, and the incoming electronic signal
lines and AC power line. The pole shall have a weatherproof, AC power
service outlet that is surge protected and has a ground fault interruption
and service outlet AC power.
2.14.3
Pan/Tilt Mounting Pole
The pan/tilt mounting pole shall be a straight steel or aluminum pole. The
pole shall be [_____] meters [_____] feet high and shall have a mounting
plate at the top for the pan/tilt. The pole and mounting plate shall have
a corrosion-resistant finish. The mounting plate shall have a bolt hole
pattern to match the base of the pan/tilt to be mounted on the pole. Under
maximum loading, the total pole deflection shall not exceed 0.1 of one
degree. A cable conduit shall be provided from the base of the pole to the
mounting plate of the pan/tilt. The conduit shall be sized to accommodate
all wiring needed for the camera and pan/tilt.
2.15
ACCESSORIES
**************************************************************************
NOTE: The designer will provide a drawing showing
the amount of rack space needed for the rack mounted
CCTV equipment, and placement of the equipment in
the rack. Coordinate the CCTV equipment rack layout
in conjunction with the ESS rack mounted equipment.
**************************************************************************
Standard 482.6 mm (19 inch) 19 inch electronic rack cabinets conforming to
EIA ANSI/EIA-310-D shall be provided for the CCTV system at the security
center and remote control/monitoring sites as shown.
2.16
WIRE AND CABLE
The Contractor shall provide all wire and cable not indicated as Government
Furnished Equipment. All wire and cable components shall be able to
withstand the environment the wire or cable is installed in for a minimum
of 20 years.
SECTION 16751A
Page 36