Fault Current Analysis[; G][; G, [_____]]
Protective Device[; G][; G, [_____]]
Coordination Study[; G][; G, [_____]]
The study shall be submitted with protective device equipment
submittals. No time extension or similar contract modifications
will be granted for work arising out of the requirements for this
study. Approval of protective devices proposed shall be based on
recommendations of this study. The Government shall not be held
responsible for any changes to equipment, device ratings,
settings, or additional labor for installation of equipment or
devices ordered and/or procured prior to approval of the study.
Nameplates[; G][; G, [_____]]
Catalog cuts, brochures, circulars, specifications, product
data, and printed information in sufficient detail and scope to
verify compliance with the requirements of the contract documents.
Material and Equipment[; G][; G, [_____]]
A complete itemized listing of equipment and materials proposed
for incorporation into the work. Each entry shall include an item
number, the quantity of items proposed, and the name of the
manufacturer of each such item.
Installation Requirements[; G][; G, [_____]]
As a minimum, installation procedures for transformers,
substations, switchgear, and splices. Procedures shall include
cable pulling plans, diagrams, instructions, and precautions
required to install, adjust, calibrate, and test the devices and
equipment.
SD-06 Test Reports
Factory Tests
Certified factory test reports shall be submitted when the
manufacturer performs routine factory tests, including tests
required by standards listed in paragraph REFERENCES. Results of
factory tests performed shall be certified by the manufacturer, or
an approved testing laboratory, and submitted within 7 days
following successful completion of the tests. The manufacturer's
pass-fail criteria for tests specified in paragraph FIELD TESTING
shall be included.
Field Testing
A proposed field test plan, [20] [30] [_____] days prior to
testing the installed system. No field test shall be performed
until the test plan is approved. The test plan shall consist of
complete field test procedures including tests to be performed,
test equipment required, and tolerance limits.
Operating Tests
[Six] [_____] copies of the tests report in 215.9 by 279.4 mm
(8-1/2 by 11 inch) 8-1/2 by 11 inch binders having a minimum of
SECTION 16375A
Page 13
Previous Page
