Detail drawings consisting of equipment drawings, illustrations,
schedules, instructions, diagrams, and other information necessary
to define the installation shall be submitted.
As-Built Drawings
The as-built drawings shall be a record of the construction as
installed. The drawings shall include all the information shown
on the contract drawings as well as all deviations, modifications,
and changes from the contract drawings, however minor.
SD-03 Product Data
Support Structures[; G][; G, [_____]]
Manufacturer's design analysis and calculations for structures,
foundations, anchor bolts, and supports differing from those
indicated in the contract drawings, and for prefabricated
structures. Calculations shall be made by a registered
professional engineer with demonstrated experience in substation
structural design in the last three years. The manufacturer shall
provide a list of projects complete with points of contact,
addresses and telephone numbers.
Fault Current Analysis
Coordination Study
The study shall be submitted along with protective device
equipment submittals. No time extensions or similar contract
modifications will be granted for work arising out of the
requirements for this study. Approval of protective devices
proposed shall be based on recommendations of this study. The
Government shall not be held responsible for any changes to
equipment, device ratings, settings, or additional labor for
installation of equipment or devices ordered and/or procured prior
to approval of the study.
Battery[; G][; G, [_____]]
Calculations for the battery and associated charger indicating
the basis used in defining loads, selecting cell types, and
determining the battery ampere-hour capacity and physical size.
Calculations shall be provided to determine capacity for the
battery charger and be similar to those shown in the Appendix to
IEEE Std 485, including explanatory data. Calculations for the
battery-charger shall demonstrate that the output voltage and
current provided are adequate to comply with the preceding
requirements.
Nameplates
Submit data composed of catalog cuts, brochures, circulars,
specifications, product data, and printed information in
sufficient detail and scope to verify compliance with the
requirements of the contract documents.
SECTION 16311A
Page 14
Previous Page
