Generators
Day tanks
Transformers (CT & PT)
Regulators
Pumps and pump motors
Governors
Generator Breaker
Economizers
Heat exchangers (other than base-mounted)
Where the following equipment is provided as a standard component by the
diesel-engine generator set manufacturer, the nameplate information may be
provided in the maintenance manual in lieu of nameplates.
Battery charger
Heaters
Exhaust mufflers
Switchgear
Silencers
Battery
1.4.3
Personnel Safety Device
Exposed moving parts, parts that produce high operating temperatures, parts
which may be electrically energized, and parts that may be a hazard to
operating personnel during normal operation shall be insulated, fully
enclosed, guarded, or fitted with other types of safety devices. The
safety devices shall be installed so that proper operation of the equipment
is not impaired.
1.4.4
Site Visit
Before performing work, the premises shall be visited and details of the
work verified. The Contracting Officer shall be advised in writing of any
discrepancies before performing any work.
1.4.5
Conformance to Codes and Standards
Where equipment is specified to conform to requirements of any code or
standard such as UL, the design, fabrication and installation shall conform
to the code.
1.4.6
Site Welding
Structural members shall be welded in accordance with Section 05090A
WELDING, STRUCTURAL. For all other welding, procedures and welders shall
be qualified in accordance with ASME BPVC SEC IX. Welding procedures
qualified by others, and welders and welding operators qualified by a
previously qualified employer may be accepted as permitted by ASME B31.1.
Welder qualification tests shall be performed for each welder whose
qualifications are not in compliance with the referenced standards. The
Contracting Officer shall be notified 24 hours in advance of qualification
tests. The qualification tests shall be performed at the work site if
practical. The welder or welding operator shall apply the assigned
personal symbol near each weld made as a permanent record
1.4.7
Engine Generator Set Enclosure
**************************************************************************
NOTE: If the engine-generator set is to be
installed out-of-doors, include requirement for the
SECTION 16264A
Page 24
Previous Page
