Strength Carbon Steel Plates
ASTM A 325
(2004b) Structural Bolts, Steel, Heat
Treated, 120/105 ksi Minimum Tensile
Strength
ASTM A 325M
(2004b) Structural Bolts, Steel, Heat
Treated, 830 Mpa Minimum Tensile Strength
(Metric)
ASTM A 36/A 36M
(2004) Carbon Structural Steel
ASTM A 49
(2001) Heat Treated Carbon Steel Joint
Bars, Microalloyed Joint Bars and Forged
Carbon Steel Compromise Joint Bars
ASTM A 53
(1999b) Pipe, Steel, Black and Hot-Dipped,
Zinc-Coated, Welded and Seamless
ASTM C 109/C 109M
(2002) Compressive Strength of Hydraulic
Cement Mortars (Using 2-in. [50-mm] Cube
Specimens)
ASTM C 144
(2003) Aggregate for Masonry Mortar
ASTM C 157
(1993) Length Change of Hardened
Hydraulic-Cement Mortar and Concrete
ASTM C 234
(1991a) Comparing Concretes on the Basis
of the Bond Developed with Reinforcing
Steel
ASTM D 1763
(2000) Epoxy Resins
U.S. DEPARTMENT OF DEFENSE (DOD)
MIL-DTL-29229
(Rev B, Notice 1) Switches and Frogs,
Track, Fabricated, for Portal Cranes
MIL-DTL-82020
(Rev C) Switches, and Frogs, Track, Cast
Manganese Steel, for Portal Cranes
MIL-STD-1699
(Rev B) Nondestructive Evaluation of Butt
Welds in Crane and Railroad Rails
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
SECTION 14606N
Page 6
Previous Page
