**************************************************************************
NOTE: Use ASME A17.1, Appendix F, for locations in
seismic risk zone 3 or greater.
**************************************************************************
Reaction loads; G
SD-07 Certificates
Welders' qualifications; G
SD-10 Operation and Maintenance Data
Elevator, Data Package 4; G
Submit in accordance with Section 01781 OPERATION AND
MAINTENANCE DATA.
Maintenance and Repair Action Plan; G
1.3
QUALITY ASSURANCE
1.3.1
Qualification
Provide pre-engineered elevator system by a manufacturer regularly engaged
in the manufacture of elevator systems. The manufacturer shall either
install elevator system or shall provide letter of endorsement certifying
that the elevator-system installer is acceptable to the manufacturer. An
installer is required to be regularly engaged in the installation and
maintenance of elevator system.
**************************************************************************
NOTE: Only in the State of Hawaii, use the
following paragraph.
**************************************************************************
[Perform work involving the installation or repair of elevator equipment
under the supervision of a person who is licensed in elevator repair in the
State of Hawaii or who possesses the equivalent experience. Furnish data
to the Contracting Officer for verification that such experience is
possessed by the person exercising direct supervision of the work.]
1.3.2
Shop Drawing Requirements
Provide assembly and arrangement of elevators, accessories, and supporting
systems. Show location of machinery and controls in machine room. Provide
details for materials and equipment, including but not limited to operating
and signal fixtures, doors, door and car frames, car enclosure,
controllers, motors, guide rails and brackets, layout of hoistway in plan
and elevation, and other layout information and clearance dimensions.
Submit complete wiring diagrams and sequence of operations, which show
electrical connections and functions of elevator systems, for the machine
room, hall and in the hoistway. Provide one set of wiring diagrams in
plastic or glass cover, framed and mounted in the elevator machine room.
Deliver other sets to the Contracting Officer. Coded diagrams are not
acceptable unless adequately identified.
SECTION 14210N
Page 7
Previous Page
