SPECIAL OPERATION AND CONTROL

Provide finishes [as indicated.][as listed below:

a.

Floor; [mill finish steel diamond plate][painted steel diamond

plate][aluminum diamond plate][tongue and groove hardwood][_____].

b.

Walls; [prefinished steel panels][stainless steel][_____].

Wall trim; [prefinished steel][stainless steel][_____].

Accessories; [handrail][_____].

c.

Interior face of doors; [prefinished steel][stainless

steel][_____].

d.

Ceiling; [prefinished steel panels][stainless steel][anodized

aluminum][_____].

e.

Hoistway Doors and Frame Finishes

Provide finishes on exterior of hoistway as follows:

(1) Frame; [prefinished steel][stainless steel][_____].

(2). Exterior face of door; [prefinished steel][stainless

steel][_____].]

]2.2

SPECIAL OPERATION AND CONTROL

Provide all special operations and control systems in accordance with ASME

A17.1. Provide special operation key switches with [5][6] pin cylinder

locks with removable cores. Provide a key control lock for each operation

system.

2.2.1

Firefighters' Service

**************************************************************************

NOTE: Firefighters' Service is required on all

freight and passenger elevators.

**************************************************************************

NOTE: Designer shall coordinate the firefighters'

designated floor level with the local base Fire

Department.

**************************************************************************

ASME A17.1, Section 211, Rule 211.3. Provide equipment and signaling

devices. The designated level for firefighters' key operated switch is the

[ground][____] floor.

2.2.2

Smoke Detectors

Smoke detectors are specified in [Section 13852, "Interior Fire Alarm

System"][____], including conduit and wiring from each detector to elevator

machinery space control panel. Provide connections directly to elevator

controls which will, when smoke is detected by any smoke detector, actuate

Firefighters' Service and send each elevator to the correct floor as

required by ASME A17.1. Provide dual-contact smoke detectors located in

the elevator lobbies and the elevator machine room. If sprinkler is

provided in the hoistway, provide dual-contact smoke detector at top of

SECTION 14210N

Page 12