NOTE: The USEPA has delegated the responsibility of
approving landfills for the disposal of asbestos to
most States. Verify with the State in which the
project is located whether the State or USEPA has
jurisdiction and what laws apply.
**************************************************************************
Submit written evidence that the landfill is for asbestos disposal by the
U.S. Environmental Protection Agency, Region 3, Air Enforcement Section
(38W12), and local regulatory agencies. Within 3 working days after
delivery, submit detailed delivery tickets, prepared, signed, and dated by
an agent of the landfill, certifying the amount of asbestos materials
delivered to the landfill. Submit a copy of the waste shipment records
within 1 day of the shipment leaving the project site.
1.3.12
Medical Certification
Provide a written certification for each worker and supervisor, signed by a
licensed physician indicating that the worker and supervisor has met or
exceeded all of the medical prerequisites listed herein and in 29 CFR
1926.1101 and 29 CFR 1926.103 as prescribed by law. Submit certificates
prior to the start of work but after the main abatement submittal.
1.4
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
SECTION 13281N
Page 16
Previous Page
