2.4.3
Glass/Cup Rack Overshelf
Glass/cup rack overshelf shall be 1.9 mm (14 gauge) 14 gauge stainless
steel with a 38 mm 1-1/2 inch deep "Vee" trough at free long sides with a
25 mm 1 inch tight hem at inside of trough. A 13 mm 1/2 inch marine edge
shall be provided at free ends and a 100 mm 4 inch high splash at the wall.
a.
Shelf shall be suspended with bottom edge at 450 mm 18 inches
above counter top.
b.
Drain tubes shall be provided at each end of trough through the
backsplash to 19 mm 3/4 inch above top of table.
c.
A horizontal rack rest of 41 mm 1-5/8 inch outside diameter
stainless steel tubing shall be provided the full length of the
shelf and shall be supported 250 mm 10 inches above the shelf on
31 mm 1-1/4 inch outside diameter stainless steel tubing spaced at
1500 mm 60 inches on center.
2.4.4
Dish/Tray Return Shelf
Dish/tray return shelf shall be sized as indicated on the drawings. Shelf
shall extend through opening in wall to be flush with the wall at the
deposit side. Shelf shall be turned down 25 mm 1 inch at 90 degrees at the
front with 19 mm 3/4 inch return at bottom. Rear long side shall be turned
down 25 mm 1 inch at 90 degrees, and shall be integral with [conveyor
slider pan] [dish counter] whenever adjacent.
2.4.4.1
Window Frame
Window frame shall be of 1.3 mm (18 gauge) 18 gauge stainless steel and
shall have the perimeter flange channel-formed, 25 by 19 mm 1 by 3/4 inch
at both sides of the wall. Corners of the frame shall be welded. The
frame shall be installed with concealed attachments. The jamb of frame
shall be aligned/abutted with the end splash of [conveyor slider pan] [dish
counter], whenever adjacent.
2.4.4.2
Overhead Rolling Door
**************************************************************************
NOTE: Designer will delete this paragraph if not
used.
**************************************************************************
An overhead rolling door shall be fitted into the dish/tray return.
Enclosure and track installation shall be coordinated with the
splash/jambs, and partition bucks.
2.5
CONVEYOR
**************************************************************************
NOTE: Designer will indicate arrangement dimensions
and details including enclosures, if required, of
the conveyors on the drawings.
**************************************************************************
2.5.1
Conveyor, Electrical
Conveyor shall be the endless belt type, electrically operated, straight,
SECTION 11400A
Page 21
Previous Page
