2.3.8.5
Food Shield
Food shield/self serve shall conform to NSF 2 and be constructed of 1.6 mm
(16 gauge) 16 gauge stainless steel, with a minimum width of at least 300
mm 12 inches and shall have a full 25 mm 1 inch skirt with 19 mm 3/4 inch
tight hem on all sides and shall be supported on stainless steel uprights
at front. All free corners shall be rounded on 19 mm 3/4 inch radius.
a.
Adjustable louver brackets below the top shall be fitted with 6 mm
1/4 inch polished, tempered plate glass or heat and mar-resistant
clear acrylic framed in an all welded stainless steel channel and
shall be installed with a 175 mm 7 inch clearance above counter
top.
b.
Fluorescent light fixtures shall be installed the full length of
the none heated undershelf displays. Display light wiring shall
be concealed in a corner post. Fixtures shall be prewired to a
single recess-mounted master switch per serving shelf.
2.4
DISH COUNTERS
**************************************************************************
NOTE: Designer will indicate dish counter layout
and details on the drawings.
**************************************************************************
Dish counters shall be constructed and sound deadened as indicated and as
specified for counters and sinks. The dish counters shall be fitted and
flanged into the dishwashing machine with a water-tight joint.
2.4.1
Dish Counter Support Channels
Dish counter support channels shall be 25 by 100 by 25 mm 1 by 4 by 1 inch,
2.7 mm (12 gauge) 12 gauge stainless steel. Channels shall be provided
under dish counter top between each pair of legs and shall have closed
ends. Cross members, on the centerline, shall be provided between legs.
Channels shall be stud-bolted to counter top at 150 mm 6 inches on center,
maximum.
2.4.2
Dish Counter Components
2.4.2.1
Scupper Drain
Scupper drain shall be provided the full width of dish counter with all
corners coved, 150 mm 6 inches wide by 50 mm 2 inches deep, and integrally
welded to the soiled/clean dish counter top at the entrance/exit of a
rack-type dishwash machine. Bottom of the scupper drain shall be scored
and sloped to 38 mm 1-1/2 inch brass drain with tailpiece. Removable
drainer shall be 1.6 mm (16 gauge) 16 gauge stainless steel, flush-mounted,
pan-formed, perforated top, shall have 13 mm 1/2 inch holes punched 38 mm
1-1/2 inches on center, and shall be installed in the scupper opening on 13
mm 1/2 inch diameter stainless steel legs with closed ends.
2.4.2.2
Prewash Sink
Integral prewash sink shall be 520 by 520 mm 20 1/2 by 20 1/2 inches welded
to the dish counter top with the corners rounded on 13 mm 1/2 inch radius.
The sink bottom shall be pitched to 1.6 mm (16 gauge) 16 gauge stainless
steel[disposer throat flange] [38 mm 1-1/2 inch brass drain]. Removable
SECTION 11400A
Page 19
Previous Page
