formed to maintain trays in proper alignment. Each section end of frame
shall be fitted with stainless steel plate notched for easy removal.
Roller section shall be mounted in trough to allow for free movement of
trays without drag. Curved sections shall have 1.9 mm (14 gauge) 14 gauge
side rails with two rollers per shaft to negotiate corner turn.
2.6
SINKS
**************************************************************************
NOTE: Designer will indicate dimension and details
of the sinks on the drawings. Remove text regarding
overflow where not applicable.
**************************************************************************
Sink shall be of the dimensions indicated and conform to the applicable
requirements of NSF 2. Sinks shall be constructed of a minimum of 1.9 mm
(14 gauge) 14 gauge stainless steel. Vertical and horizontal corners shall
be rounded to a radius of not less than 19 mm 3/4 inch with double walls at
partitions. Continuous 1.9 mm (14 gauge) 14 gauge stainless steel exterior
filler panels shall be provided between compartments of
multiple-compartment sinks and shall be ground and polished to match the
adjacent surfaces. The sink bottom shall be scored and sloped to assure
drainage to the waste outlet. Sinks shall be equipped with waste and
overflow fittings, drain plugs with quick-opening valves, and faucets of
the type specified. Faucet and drain plug, and overflow fitting shall be
required for each sink compartment, unless otherwise indicated. Spout
outlet of faucets shall be a minimum of 125 mm 5 inches above the rim of
the sink. Sink legs shall be as specified for counters, except that closed
gussets shall be welded to the support channels. Sinks installed adjacent
to walls or enclosures shall be anchored and sealed thereto. Sinks shall
be sound-deadened as specified for counters.
2.6.1
Plumbing/Trim Requirements
2.6.1.1
Drain Plug and Overflow Fittings
Drain shall consist of a 38 mm 1-1/2 inch quick opening brass body valve
with side outlet overflow connection with a stainless steel twist lever
handle. Removable perforated stainless steel strainer plate shall be not
less than 75 mm 3 inches in diameter. Overflow fittings shall consist of
31 mm 1-1/4 inch diameter chrome-plated brass tubing of not less than 0.91
mm 0.036 inch thickness connected to an overflow head in the back of the
sink compartment. Overflow head shall have a removable perforated
chrome-plated brass or stainless steel strainer plate of not less than 38
mm 1-1/2 inch diameter. Overflow head shall be installed in die-stamped
opening 25 mm 1 inch below counter top.
2.6.1.2
Backsplash-Mounted Faucets
**************************************************************************
NOTE: Designer will detail location and type of
faucets. Stainless steel will be specified for
hospital faucets.
**************************************************************************
Backsplash-mounted faucets shall be combination fitting-type with an
exposed body and concealed supply connections at the back of the sink.
Fitting shall have a swinging spout of approximately 200 mm 8 inches in
length and inlets with 19 mm 3/4 inch pipe thread. Faucets shall have
SECTION 11400A
Page 24