adjustable flanges.
Valves shall have indexed metal lever handles and
replaceable seats.
2.6.1.3
Counter Top or Ledge-Mounted Faucets
**************************************************************************
NOTE: Designer will detail location and type of
faucets. Stainless steel will be specified for
hospital faucets.
**************************************************************************
Counter top or ledge-mounted faucets shall be combination fitting-type with
a concealed body and with the supply connections under the sink ledge or
counter top. The faucets shall have replaceable valve seats, swinging
spout elevated to clear valve handle, and four-arm or lever-style indexed
metal handles. Chrome-plated copper alloy or stainless steel escutcheons
for valves and spout, locknuts and washers or lock-nut type escutcheons
together with coupling nuts, and 13 mm 1/2 inch pipe size union-tailpieces
shall be provided.
2.6.1.4
Control Valve Mountings
Gusset-shaped 1.9 mm (14 gauge) 14 gauge stainless steel panel for the
control valves shall be mounted on open base fixtures with 88 mm 3-1/2 inch
setback from the countertop edge/rim to the valve handle.
2.6.2
Pot Washing Sinks
2.6.2.1
Final Rinse Compartment
The final rinse compartment of the pot washing sink shall be equipped with
a booster heater for sanitizing.
2.6.2.2
Temperature Gauge
Temperature gauge shall have a 75 mm 3 inch diameter face with stainless
steel flange.
2.6.2.3
Valves, Temperature Gauge, and Controls Mounting
Valves, temperature gauge, and controls shall be installed in a stainless
steel recessed panel, ready for final connections. A perforated stainless
steel casing shall be provided over the temperature bulb.
2.6.2.4
False Bottom
False bottom shall be constructed of 1.9 mm (14 gauge) 14 gauge stainless
steel, 13 mm 1/2 inch deep pan formed with a perforated top (13 mm 1/2 inch
holes punched 38 mm 1-1/2 inches on center), and shall have welded corners
and finger rings. False bottom shall be fitted with 50 mm 2 inch high by
31 mm 1-1/4 inch outside diameter tubular stainless steel feet with closed
ends.
2.6.3
Cutlery and Excess Liquid Sinks
Cutlery and excess liquid sinks shall have a removable standpipe overflow,
in lieu of an overflow in the back of the sink. The overflow shall be
installed in the corner of the sink compartment. Compartments shall be
provided with snug-fitting removable basket strainers. Drain plug with
SECTION 11400A
Page 25
Previous Page
