2.3.7.2
Tube Type Slide
Tube type slide shall consist of a minimum of three 25 mm 1 inch diameter
tubes with supporting hardware. The tray slide shall have the ends of each
tube closed. The tubes shall be fabricated of stainless steel in the 300
series with a minimum thickness of 1.6 mm (16 gauge) 16 gauge.
2.3.7.3
Support Brackets
Support brackets for tray slides shall be [stainless steel] [cast-brass
chromium-plated], and shall be secured to the trim strip of the counter
with stainless steel truss head bolts. Brackets shall not be spaced more
than 1200 mm 48 inches, center to center.
2.3.8
Protector Shelf
Protector shelf shall be installed on the serving line counters and shall
be located over the equipment as indicated. Protector/serving shelf shall
be constructed of 1.6 mm (16 gauge) 16 gauge stainless steel, with a
minimum width of at least 300 mm 12 inches, and shall have a full 25 mm 1
inch skirt with 19 mm 3/4 inch tight hem on all sides and shall be
supported on stainless steel uprights, at front. All free corners shall be
rounded on a 19 mm 3/4 inch radius.
2.3.8.1
Heat Lamps
Heat lamp units shall be provided with consolidated chassis of longest
possible length for multiple sections. Heat lamp units shall have integral
incandescent display light with warm white lamps and shall be wired to a
recess mounted infinitely adjustable heat control with pilot light for each
separate section. Heat lamps shall be secured tightly to the underside of
the serving shelf and shall have a "USDA" approved heat protector provided
between the heat lamps and the shelf. Maximum allowable temperature at the
top of a serving shelf shall be 49 degrees C 120 degrees F.
2.3.8.2
Fluorescent Display Light Modules
Fluorescent display light modules (not included with heat lamps) shall be
in 450 mm 18 inch and 900 mm 36 inch increments, each with [regular or
deluxe white T-8 energy efficient lamps.] [lamps as indicated on the
drawings.] Display lamps shall be wired to a single recess mounted master
switch per serving shelf.
2.3.8.3
Heat Lamp/Display Wiring
Heat lamp/display wiring shall be concealed in a corner post.
2.3.8.4
Protector Glass
Protector glass sheet shall be no less than 6 mm 1/4 inch thick in
transparent, tempered plate glass or heat- and mar-resistant clear acrylic
framed in an all welded stainless steel channel edging and shall be
installed under the protector shelf and in front of the food display. At
the top and bottom of the installed glass shall be a 25 mm 1 inch space for
vapor venting. The protector glass or clear acrylic shall be pivoted for
easy cleaning. Design shall be such that glass or clear acrylic can be
replaced in the event of breakage.
SECTION 11400A
Page 18