2.3.5
Feet
Feet shall be sanitary, die-stamped stainless steel bullet-shaped, fully
enclosed and shall provide for a 25 mm 1 inch adjustment without threads
being exposed. The bottom of the legs shall be finished off smoothly and
the stem overlapped to provide a sanitary closed fitting. Feet for
free-standing fixtures requiring utility connections shall be as above
except with a flanged plate at the bottom which shall be anchored to the
floor with noncorrosive bolts.
2.3.6
Undercounter Shelving
2.3.6.1
Open Base Shelves
Open base shelves shall be constructed of 1.6 mm (16 gauge) 16 gauge
stainless steel with all edges turned down 38 mm 1-1/2 inches at 90 degrees
with a 19 mm 3/4 inch tight hem at bottom. Corners shall be notched a full
90 degrees and welded from underside to completely fill the gap, ground and
polished. Undershelf shall be braced with 25 by 100 mm 1 by 4 inch, 1.9 mm
(14 gauge) 14 gauge stainless steel channel at longitudinal center line and
between each intermediate pair of legs.
2.3.6.2
Closed Base Shelves
Interior shelves on closed bases shall be constructed of 1.6 mm (16 gauge)
16 gauge stainless steel. Side edges of the shelf shall be turned up 50 mm
2 inches at 90 degrees on a 6 mm 1/4 inch radius and sealed to the side
walls. Rear of the shelf shall be coved up at 90 degrees on a 16 mm 5/8
inch radius to shelf above or counter top, flanged out for attachment with
no open space at interior. Vertical joints shall be sealed. Front edge
shall be turned down 50 mm 2 inches at 9O degrees with a 19 mm 3/4 inch
tight hem. The vertical seam of shelf turn down/turn up shall be welded to
the face of body partition. Maximum depth of shelves shall be [560]
[_____] mm [22] [_____] inches. Shelves shall be reinforced with 25 by 100
mm 1 by 4 inch, 1.9 mm (14 gauge) 14 gauge stainless steel closed hat
channel. Shelf slides, where indicated, shall be 1.9 mm (14 gauge) 14 gauge
stainless steel, 38 by 38 mm 1-1/2 by 1-1/2 inch angles, and shall have
front and back corners rounded and finished smooth.
2.3.7
Tray Slides
Tray slides shall be [solid type] [tube type]. The width of the tray
slides shall not be less than 360 mm 14 inches. The mounting height of the
tray slides shall be 850 mm 34 inches above the finished floor. Tray
slides shall be installed true and level. Tray slide shall be designed and
installed to preclude tray spillage.
2.3.7.1
Solid Type Slide
Solid type slide shall be constructed of 1.9 mm (14 gauge) 14 gauge
stainless steel with the front edge rolled 44 mm 1-3/4 inches at 180
degrees. The top edge of the roll shall be 10 mm 3/8 inch above the flat
surface of the slide. Two inverted "V" forms, approximately 10 mm 3/8 inch
high, shall be provided in the flat surface of the slide as the running
surface for trays. The back edge of the slide shall be turned up 25 mm 1
inch at 90 degrees behind counter top turn down. Ends of the slide shall
be closed to eliminate sharp edges.
SECTION 11400A
Page 17
Previous Page
