DIVISION 3: EXTERIOR CONCRETE PAINT TABLE (cont.)

DIVISION 3: EXTERIOR CONCRETE PAINT TABLE

and soffits but excluding tops of slabs:

1. [Elastomeric Coating

New; MPI EXT 3.1F / Existing; MPI REX 3.1F

Primer:

Intermediate:

Topcoat:

Per Manufacturer

MPI 113

System DFT: 16 mils 400 microns

Primer as recommended by manufacturer. Topcoat: Coating to match

adjacent surfaces. Surface preparation and number of coats in accordance

with manufacturer's instructions.

NOTE: Apply sufficient coats of MPI 113 to achieve a minimum dry film

thickness of 16 mils 400 microns.]

D.

[New and uncoated existing] [and Existing, previously painted] concrete:

walls and bottom of swimming pools.

1. [Chlorinated Rubber

New; / Existing;

Primer:

Intermediate:

Topcoat:

SSPC Paint 18

System DFT: Per Manufacturer

NOTE: Thin first coat (primer) with 1 part of approved thinner to 4

parts of paint by volume.]

E.

[New] [and Existing] Cementitious composition board (including Asbestos

cement board):

1. [Latex

[New; MPI EXT 3.3A-G1 (Flat) /Existing; MPI REX 3.3A-G1 (Flat)

Primer:

Intermediate:

Topcoat:

MPI 10

System DFT: 4.5 mils 112 microns]

[New; MPI EXT 3.3A-G5 (Semigloss) / Existing; MPI REX 3.3A-G5 (Semigloss)

Primer:

Intermediate:

Topcoat:

MPI 11

System DFT: 4.5 mils 112 microns]

[New; MPI EXT 3.3A-G6 (Gloss) / Existing; MPI REX 3.3A-G6 (Gloss)

Primer:

Intermediate:

Topcoat:

MPI 119

System DFT: 4.5 mils 112 microns]

Topcoat:

Coating to match adjacent surfaces.]

**************************************************************************

NOTE: (DIVISION 4: EXTERIOR CONCRETE MASONRY UNITS

PAINT TABLE). For applications of high-build glaze

finishes over concrete masonry units requiring block

filler that meets resistance to wind-driven rain or

resistance to hydrostatic pressure, specify filler

materials and applications of Section 09963

HIGH-BUILD GLAZE COATING.

SECTION 09900

Page 43