[liter.] [gallon.] The use of thinner shall not relieve the Contractor
from obtaining complete hiding, full film thickness, or required gloss.
Thinning shall not cause the paint to exceed limits on volatile organic
compounds. Paints of different manufacturers shall not be mixed.
3.8.3
Two-Component Systems
Two-component systems shall be mixed in accordance with manufacturer's
instructions. Any thinning of the first coat to ensure proper penetration
and sealing shall be as recommended by the manufacturer for each type of
substrate.
3.8.4
Coating Systems
**************************************************************************
NOTE: Delete Divisions from the Table listing below
that are not required for the project.
**************************************************************************
a.
Systems by Substrates: Apply coatings that conform to the
respective specifications listed in the following Tables:
Table
Division
3.
Exterior Concrete Paint Table
Division
4.
Exterior Concrete Masonry Units Paint Table
Division
5.
Exterior Metal, Ferrous and Non-Ferrous Paint Table
Division
6.
Exterior Wood; Dressed Lumber, Paneling, Decking,
Shingles Paint Table
Division 9: Exterior Stucco Paint Table
Division 10. Exterior Cloth Coverings and Bituminous Coated
Surfaces Paint Table
Division
3.
Interior Concrete Paint Table
Division
4.
Interior Concrete Masonry Units Paint Table
Division
5.
Interior Metal, Ferrous and Non-Ferrous Paint Table
Division
6.
Interior Wood Paint Table
Division
9:
Interior Plaster, Gypsum Board, Textured Surfaces
Paint Table
b.
Minimum Dry Film Thickness (DFT): Apply paints, primers,
varnishes, enamels, undercoats, and other coatings to a minimum
dry film thickness of 0.038 mm 1.5 mil each coat unless specified
otherwise in the Tables. Coating thickness where specified,
refers to the minimum dry film thickness.
c.
Coatings for Surfaces Not Specified Otherwise: Coat surfaces
which have not been specified, the same as surfaces having similar
conditions of exposure.
d.
Existing Surfaces Damaged During Performance of the Work,
Including New Patches In Existing Surfaces: Coat surfaces with
the following:
(1)
One coat of primer.
(2)
One coat of undercoat or intermediate coat.
(3)
One topcoat to match adjacent surfaces.
SECTION 09900
Page 38
Previous Page
