soils).
If the Government is to perform sampling and
analyses, specify what data will be available from
the Government. This will enable the Contractor to
ascertain if additional analysis will be required by
the TSD facility and should be reflected in the bid.
See EM 200-1-3, Requirements for Preparation
Sampling and Analysis Plans, for additional
information.
**************************************************************************
Tank [product,] [pumpable liquids,] [tank coatings] [and] [sludge] [shall]
[shall not] be sampled by the Contractor. If the data is not adequate,
additional sampling and analysis to the extent required by the approved
[off-site] [permitted treatment, storage or disposal (TSD)] facility
receiving the material shall be the responsibility of the [Contractor]
[Government]. Meeting all regulatory requirements, including the
the responsibility of the Contractor.
3.2.2
Analysis
**************************************************************************
NOTE: The designer will consult the state/local
regulations and EM 1110-3-178 for assistance in
determining the appropriate analytical parameters
for tank contents samples. Analytical protocol will
and/or tank contents testing and defined in Section
01450 CHEMICAL DATA QUALITY CONTROL. The designer
will ensure that the Contractor addresses the
specific laboratory preparation and analytical
methods to be employed, especially variations in
fuel related analyses.
**************************************************************************
Tank contents shall be tested by the [Government] [Contractor] for the
parameters listed herein. Analyses shall include [total petroleum
hydrocarbons (TPH)] [benzene, ethylbenzene, toluene and xylene (BETX)]
[lead] [_____].
3.2.3
Characterization
**************************************************************************
NOTE: Regarding "in a special manner", some states
require that petroleum contaminated soils (special
wastes) be disposed of in specially designated
landfills.
Refer to EM-1110-3-178 for additional information.
**************************************************************************
[Prior to removing any of the tank contents, the contents shall be
characterized to determine if the tank contents must be disposed [as a
[hazardous] [special] waste] [in a special manner] based on local, state,
and Federal disposal regulations. [Tank product] [Tank product, pumpable
liquids, and sludge] shall be characterized in accordance with 40 CFR 261
SECTION 02115A
Page 13