UNDERWRITERS LABORATORIES (UL)
UL 467
(2004) Grounding and Bonding Equipment
UL 486A-486B
(2003; Rev thru Apr 2004) Wire Connectors
1.2
GENERAL REQUIREMENTS
**************************************************************************
NOTE: Select the features and fill in blanks with
selections appropriate for the design condition and
in accordance with guidance contained in TM 5-811-1.
**************************************************************************
1.2.1
Terminology
Terminology used in this specification is as defined in ANSI C42.100.
1.2.2
Service Conditions
**************************************************************************
NOTE: See TM 5-811-1 for guidance regarding service
conditions. Retain or add the required conditions.
Provide seismic requirements, if a Government
designer (either Corps office or A/E) is the
Engineer of Record and show on the drawings. Delete
the bracketed phrase if seismic details are not
included. Sections 13080, 15070A and 16070A,
properly edited, must be included in the contract
documents.
**************************************************************************
Items provided under this section shall be specifically suitable for the
following service conditions. Seismic details shall conform to Sections
13080 SEISMIC PROTECTION FOR MISCELLANEOUS EQUIPMENT, 15070A SEISMIC
PROTECTION FOR MECHANICAL EQUIPMENT, and 16070A SEISMIC PROTECTION FOR
ELECTRICAL EQUIPMENT [as indicated].
a.
Fungus Control [_____]
b.
Altitude [_____]
c.
Ambient Temperature [_____]
d.
Frequency [_____]
e.
Seismic Parameters [_____]
f.
Corrosive Areas [_____]
g.
[_____]
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
SECTION 16370A
Page 9
Previous Page
