component shall be environmentally suitable for the location shown and
shall be the manufacturer's standard product offered in catalogs for
commercial or industrial use. Any nonstandard products or components and
the reason for their use shall be specifically identified in paragraph
SUBMITTALS.
1.4.2
Nameplates
**************************************************************************
NOTE: Delete any equipment not applicable to the
project.
**************************************************************************
Each major component of this specification shall have the manufacturer's
name, type or style, model or serial number and rating on a plate secured
to the equipment. As a minimum, nameplates shall be provided for:
Engines
Generators
Transformers (CT & PT)
Regulators
Day tanks
Pumps and pump motors
Governors
Generator Breaker
Air Starting System
Economizers
Heat exchangers (other than base
mounted)
Where the following equipment is not provided as a standard component by
the diesel engine generator set manufacturer, the nameplate information may
be provided in the maintenance manual in lieu of nameplates.
Battery charger
Heaters
Switchboards
Exhaust mufflers
Switchgear
Silencers
Battery
1.4.3
Personnel Safety Devices
Exposed moving parts, parts that produce high operating temperatures, parts
which may be electrically energized, and parts that may be a hazard to
operating personnel shall be insulated, fully enclosed, guarded, or fitted
with other types of safety devices. The safety devices shall be installed
so that proper operation of the equipment is not impaired.
1.4.4
Site Visit
Before performing any work, the premises shall be visited and all details
of the work verified. The Contracting Officer shall be advised in writing
of any discrepancies.
1.4.5
Conformance to Codes and Standards
Where equipment is specified to conform to requirements of any code or
standard such as UL, NEMA, etc., the design, fabrication and installation
shall also conform to the code.
1.4.6
Site Welding
Structural members shall be welded in accordance with Section 05090A
WELDING, STRUCTURAL. For all other welding, procedures and welders shall
be qualified in accordance with ASME BPVC SEC IX. Welding procedures
SECTION 16263A
Page 29
Previous Page
