operating or maintenance personnel and securely mounted to or attached in
proximity of their identified controls or equipment. Lettering shall be
normal block lettering, a minimum of 6.4 mm 0.25 inch high.
2.4.1
Materials
Construct ID plates and tags of 16 gage minimum thickness bronze or
stainless steel sheet metal engraved or stamped with inscription.
Construct plates and tags not exposed to the weather or high operational
temperature of the diesel engine of laminated plastic, 3.2 mm 0.125 inch
thick, matte white finish with black center core, with lettering accurately
aligned and engraved into the core.
2.4.2
Control Devices and Operation Indicators
Provide ID plates or tags for control devices and operation indicators,
including valves, off-on switches, visual alarm annunciators, gages and
thermometers, that are required for operation and maintenance of provided
mechanical systems. Plates or tags shall be minimum of 13 mm 0.5 inch high
and 50 mm 2 inches long and shall indicate component system and component
function.
2.4.3
Equipment
Provide ID plates of a minimum size of 75 mm 3 inches high and 130 mm 5
inches long on provided equipment indicating the following information:
a.
Manufacturer's name, address, type and model number, and serial number;
b.
Contract number and accepted date;
c.
Capacity or size;
d.
System in which installed; and
e.
System which it controls.
2.5
ASSEMBLED OPERATION AND MAINTENANCE MANUALS
The contents of the assembled operation and maintenance manuals shall
include the manufacturer's O&M information required by the paragraph
entitled "SD-10, Operation and Maintenance Data" and the manufacturer's O&M
information specified in Section 16410N AUTOMATIC TRANSFER SWITCHES.
a.
Manuals shall be in separate books or volumes, assembled and bound
securely in durable, hard covered, water resistant binder, and indexed
by major assembly and components in sequential order.
b.
A table of contents (index) shall be made part of the assembled O&M.
The manual shall be assembled in the order noted in table of contents.
c.
The cover sheet or binder on each volume of the manuals shall be
identified and marked with the words, "Operation and Maintenance
Manual."
2.6
SOURCE QUALITY CONTROL
**************************************************************************
NOTE: Include the bracketed option below for
SECTION 16237N
Page 36
Previous Page
