Functional Performance Test Checklist - Unit Heaters
The Contracting Officer will select unit heaters to be spot-checked during
the functional performance test. The number of terminals shall not exceed
[2] [10] [10 percent].
1. Functional Performance Test: Contractor shall demonstrate operation of
selected unit heaters as per specifications including the following:
a. Verify unit heater response to room temperature set point
adjustment. Changes to be heating set point to heating set point minus 10
degrees and return to heating set point. ___________________________________
b.
Check blower fan speed.
_______________________________________rpm
c. Check heating mode inlet air temperature. _____ degrees C
Check
heating mode inlet air temperature. _____ degrees F
d. Check heating mode outlet air temperature. _____ degrees C
Check
heating mode outlet air temperature. _____ degrees F
2. Certification: We the undersigned have witnessed the above functional
performance tests and certify that the item tested has met the performance
requirements in this section of the specifications.
Signature and Date
Contractor's Chief Quality Control Representative
_____________________________
Contractor's Mechanical Representative
_____________________________
Contractor's Electrical Representative
_____________________________
Contractor's Testing, Adjusting and Balancing Representative
_____________________________
Contractor's Controls Representative
_____________________________
Contracting Officer's Representative
_____________________________
Using Agency's Representative
_____________________________
SECTION 15995A
Page 59
Previous Page
