panel box number, and physical location of each controller's source of AC
power.
1.8.5
Contractors Qualifications
a.
The Contractor or subcontractor performing the work shall have
completed at least three DDC systems installations of a similar
design and have successfully operated a similar sequence of
operation for at least three years.
1.8.6
Pressure Tank Certification
Provide certification stating pressure tanks are constructed and labeled in
accordance with ASME BPVC SEC VIII for a minimum of 125 psig working
pressure.
1.8.7
Training Course Documentation
Training course documentation including a manual for each trainee plus two
additional copies and one copy of audiovisual training aids, if used.
Documentation shall include an agenda, defined objectives for each lesson
and detailed description of the subject matter of each lesson.
1.8.8
Service Organizations
Qualified service organization list including the names and telephone
numbers of organizations qualified to service the HVAC control systems.
1.8.9
Contractor Certification
Provide certification that installation of the control system is complete
and meets the technical requirements of this section.
1.8.10
Controls and HVAC System Operators Manual
Provide two copies of a Control and HVAC Systems Operators Manual. Provide
in a 3 ring binder with a minimum of the following 7 sections. Use tabs to
divide each section.
a.
Description of HVAC Systems: Provide a description of the HVAC
system components and control system. Include sequence of
operation and a complete points list.
b.
Controls Drawings:
Provide drawings as specified in submittal
paragraph.
c.
Control Program Listings: Provide listing of all control
programs, including terminal equipment controller setup pages if
used.
d.
Current Operating Parameters: Provide printouts of input and
output setup information, (database setups). This section
provides information such as point addresses, slopes and offsets
for all points, database of points, etc.
e.
Design Information:
Include relevant design data and calculations.
f.
Control Equipment Technical Data Sheets: Provide technical data
sheets for all controller hardware and accessories.
SECTION 15910N
Page 23
Previous Page
