1.5.1.2
Electrical Equipment Ladder Diagrams
Submit diagrams showing electrical equipment interlocks, including voltages
and currents.
1.5.1.3
Component Wiring Diagrams
Submit a wiring diagram for each type of input device and each type of
output device. Diagram shall show how the device is wired and powered;
showing typical connections at the digital controller and each power
supply, as well as at the device itself. Show for all field connected
devices, including, but not limited to, control relays, motor starters,
electric or electronic actuators, and temperature, pressure, flow, proof,
and humidity sensors and transmitters.
1.5.1.4
Terminal Strip Diagrams
Submit a diagram of each terminal strip, including digital controller
terminal strips, terminal strip location, termination numbers and
associated point names.
1.5.1.5
Communication Architecture Schematic
Submit a schematic showing communication networks used for all DDC system
controllers, workstations, and field interface devices.
1.6
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
SECTION 15910N
Page 17
Previous Page
