(9)
Oil temperature at outlet of heater:
[_____] degrees C F
(10)
Maximum oil pressure drop through heater:
[_____] kPa psi
(11)
Heating medium:
Steam
(12)
Steam pressure available:
[_____] kPa (gage) psig
(13)
Steam temperature:
[_____] degrees C F
(14)
Heater type:
[Extended surface][Bare tube]
b.
Electric startup heater
(1)
Oil temperature at heater inlet:
[_____] degrees C F
(2)
Oil temperature at heater outlet:
[_____] degrees C F
(3)
Maximum oil pressure drop through heater:
[_____] kPa psi
(4)
Capacity of heater:
[_____] L/s gpm
(5)
Heating power supply at three phase, 60 Hz [_____] volts
(6)
Control power supply 120 volts, single phase, 60 Hz
1.4.1.10
Ash Handling System (Mechanical)
a.
Capacity:
(1) Ash handling system: Estimated capacities at maximum plant
output are listed below; ash handling system capacity shall be
sized for twice the amounts listed.
[_____] Mg tons per hour for fly ash
[_____] Mg tons per hour for bottom ash
[_____] Mg tons per hour in bucket elevator leaving the boiler
house (minimum).
(2) Ash silo: Storage capacity of ash silo is specified in the
paragraph entitled "Ash Storage Silo."
(3)
Rotary unloader:
[_____] Mg tons per hour
b.
General data
(1)
Available water pressure:
[_____] kPa (gage) psig
(2)
Available air pressure:
[_____] kPa (gage) psig
(3)
Seismic zone:
[_____]
(4)
Wind velocity (gusts):
[_____] km/hr mph
(5)
Altitude of plant:
[_____] m ft
(6)
Steam rating of plant:
[_____] kg/s lb/hr
SECTION 15502N
Page 31
Previous Page
