c.
Fuel oil recirculation pump sets (at remote storage):
**************************************************************************
NOTE: At the text below, the values enclosed in
brackets are for No. 6 Low Sulfur fuel oil. Adjust
values to suit fuel oil used when other than No. 6.
**************************************************************************
(1)
Number of assemblies:
[_____]
(2)
Tag numbers:
As indicated
(3)
Capacity:
1.58 L/s 25 gpm at 450 ssu
(4)
Suction lift required:
[_____] kPa ft. water
(5)
Discharge pressure:
[_____] kPa (gage) psig
(6)
Operating temperature:
[49120] [_____] degrees C F
(7)
Viscosity range:
[450 to 3000] [_____ to _____] ssu
(8)
Specific gravity:
[.92 to .99] [_____ to _____]
(9)
Viscosity at brake power point:
[5000] [_____] ssu
(10) Maximum pump speed:
1750 rpm
(11) Motor kW hp:
[_____]
(12) Fuel oil:
No. [6, low sulfur] [_____]
1.4.1.9
Fuel Oil Pump and Heater Set for Fuel Oil System
**************************************************************************
NOTE: At the text below, the values enclosed in
brackets are for No. 6 Low Sulfur fuel oil. Adjust
values to suit fuel oil used when other than No. 6.
**************************************************************************
a.
Pump/heater set
(1)
Capacity each pump and each steam heater:
[_____] L/s gpm
(2)
Suction lift:
[_____] kPa ft water
(3) Discharge pressure at outlet of heater:
[_____] kPa (gage)
psig
(4)
Maximum pump speed:
1750 rpm
(5)
Specific gravity range:
[.92 to .99] [_____ to _____]
(6)
Viscosity at brake power point:
5000 ssu
(7)
Viscosity range:
[500 to 5000] [_____ to _____] ssu
(8)
Oil temperature at inlet of heater:
[_____] degrees C F
SECTION 15502N
Page 30
Previous Page
