Moisture
[_____]
[_____]
[_____]
[_____]
Oxygen
[_____]
[_____]
Btu per pound
[_____]
[_____]
Ash softening temperature
[_____]
[_____]
Volatile matter
[_____]
[_____]
Fixed carbon
[_____]
[_____]
[b.
Fuel Oil Analysis
**************************************************************************
NOTE: Use Fuel Oil Analysis Schedule only if fuel
oil burners are used.
**************************************************************************
Grade of Fuel Oil:
Ultimate Analysis (percent by weight)
Carbon
[_____]
[_____]
Oxygen
[_____]
[_____]
Sulfur
[_____]
Ash
[_____]
Moisture
[_____]
TOTAL
[_____]
Heating Valve: [_____] kJ/kg Btu per pound
Specific Gravity: [_____] degrees API
Viscosity at burner
[_____] (SSF at 50 degrees C 122 degrees F
[_____] Water and Sediment (percent by volume)
[_____] Flash Point degrees C F]
Submit predicted economizer performance along with and as a part of the
boiler predicted performance.
1.4.4.2
Economizer
Increase in efficiency due to the economizer shall be not less than [_____]
percent at full load. Fully coordinate economizer with the boiler to which
it is to be applied.
1.4.4.3
Oil Burner/Windbox Package
Burner turndown ratio on specified fuel oil shall be not less than eight to
one, with excess air not over 15 percent at full steam load, and excess air
not over 22 percent at 20 percent steam load. [Air flow shall be modulated
through a single set of register louvers.]
1.5
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
SECTION 15501N
Page 35
Previous Page
