Section 1
Materials and Fabrication
Section 2
Vertical Pumps
Section 3
Factory Test
Section 4
Electric Motor or Diesel Engine
Section 5
Reduction Gear
Section 6
Services of Erecting Engineer
**************************************************************************
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI S2.19
(1999) Mechanical Vibration - Balance
Quality Requirements of Rigid Rotors, Part
1: Determination of Permissible Residual
Unbalance, Including Marine Applications
(Note: was ASA86, but that document refers
to ANSI S2.19.)
AMERICAN PETROLEUM INSTITUTE (API)
API RP 686
(1996) Recommended Practice for Machinery
Installation and Installation Design
AMERICAN WATER WORKS ASSOCIATION(AWWA)
AWWA C200
(1997) Steel Water Pipe - 6 In. (150 mm)
and Larger
AWWA C203
(2002; A C203a-99) Coal-Tar Protective
Coatings and Linings for Steel Water
Pipelines - Enamel and Tape - Hot-Applied
AWWA C207
(2001) Steel Pipe Flanges for Waterworks
Service - Sizes 4 In. Through 144 In. (100
mm Through 3,600 mm)
AWWA C208
(2001) Dimensions for Fabricated Steel
Water Pipe Fittings
AMERICAN WELDING SOCIETY (AWS)
AWS D1.1/D1.1M
(2004) Structural Welding Code - Steel
SECTION 15131A
Page 6
Previous Page
