control, process, integrate, and annunciate IDS data [at [two]
[_____] separate locations].
f.
Power subsystem: Components required to ensure continuous
operation of the entire IDS.
2.2.1
Growth Capability
Provide capability for modular IDS expansion with minimal equipment
modification. Products provided shall not limit growth capability to
products of a single manufacturer.
[2.2.2
Intrinsically Safe
**************************************************************************
NOTE: Do not locate alarm reporting and display
equipment within a hazardous area. If point sensors
and volumetric sensors are required in hazardous
areas, clearly identify their location on the plans.
Delete this paragraph if no hazardous areas exist
in this project.
**************************************************************************
System components located in areas where fire or explosion hazards may
exist due to flammable gases or vapors, flammable liquids, combustible
dust, or ignitable fibers or flyings shall be rated and installed according
to Chapter 5 of NFPA 70. Classification of area and corresponding
equipment ratings and installation procedures shall be as defined and
specified in Chapter 5 of NFPA 70.
]2.3
INTEGRATED SYSTEM PERFORMANCE REQUIREMENTS
The installed and operating IDS shall be integrated into the overall
facility to detect intrusion and shall perform as an entity, as specified
below.
2.3.1
Detection Coverage
Provide and adjust sensors so that coverage is [overlapping and] maximized
without mutual interference. [IDS coverage shall include [the facility
perimeter] [and] critical spaces within the facility.]
2.3.2
Detection Resolution (Sensitivity)
Sensitivity shall be capable of the following:
a.
Locating intrusions [within [100] [_____] meter zones along a line
or perimeter] [to one side of the [facility] [building]];
b.
Locating intrusions at individually protected assets or at an
individual portal;
c.
Locating intrusions within volume or areas to within the coverage
on a single volumetric sensor; and
d.
Locating failures or tampering at individual sensors.
SECTION 13703N
Page 16
Previous Page
