electrical power cabinets.
2. Site Plan: Exterior devices and routing of
conductors and conduit into building.
3. Single line type system riser diagram. Label
zones on riser diagrams. Connection of equipment
should be indicated for typical system chosen for
cost estimating purposes.
4.
Single line type electrical riser diagram.
5. Mounting: Details for each device required for
complete installation. Include device height and
installation of wiring.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM A 123/A 123M
(2002) Zinc (Hot-Dip Galvanized) Coatings
on Iron and Steel Products
ASTM B 32
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA ICS 2
(2000; R
2004) Industrial Controls and
Systems:
Controllers, Contactors, and
Overload
Relays Rated Not More than 2000
Volts AC
or 750 Volts DC
NEMA ICS 6
(1993; R 2001) Industrial Control and
Systems: Enclosures
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 70
(2005) National Electrical Code
SECTION 13702N
Page 5