2.4.12
Drawers
Die-stamped 1.2 mm thick 18 gage stainless steel, 500 by 500 by 125 mm 20
by 20 by 5 inch deep. Drawer body shall be easily removed for cleaning
with top edges flanged out 13 mm 0.5 inch. Round interior horizontal
corners on a 25 mm one inch radius and interior vertical corners on a 50 mm
2 inch radius. Fabricate supporting frame of 1.8 mm thick 14 gage
stainless steel channel. Weld drawer face to frame. Die-stamp drawer face
with raised border for rigidity. Die-form an integral open sanitary handle
into face. Mount drawer slides with ball bearing nylon or stainless steel
rollers on channel frame. Slides and frame shall allow for full opening of
drawer, and be reinforced to support a weight of 22.5 kilograms 50 pounds
when fully extended. Provide stops for each drawer at fully open position.
Enclose drawers on open-base tables in 1.2 mm thick 18 gage stainless
steel housing.
2.4.13
Doors
Stainless steel double-cased. 1.2 mm thick 18 gage outer pan with corners
welded, ground smooth and polished. 0.9 mm thick 20 gage inner pan fitted
tightly into outer pan with core of sound deadening material. Tack-weld
outer and inner pans together with solder-filled seam. Provide doors
approximately 20 mm 0.75 inch thick and fitted with flush-recessed,
stainless steel door pulls. Mount doors on stainless steel piano or
concealed hinges.
2.4.14
Tray Slide
**************************************************************************
NOTE: Tray slides for Enlisted General Messes shall
be installed as an integral fabrication of serving
line counterfront; NAVFSSO drawing 11103-857 and as
specified in the applicable Standard for other
equipment.
**************************************************************************
[Solid] [Tube] type, 300 mm 12 inch wide; mounted 865 mm 34 inches above
floor. Extend to full length of supporting counter.
2.4.14.1
Solid Type
1.8 mm thick14 gage stainless steel with front and back edges rolled 45 mm
1.75 inch at 180 degrees. Top edge of roll shall be 10 mm 0.375 inch above
flat surface of slide. Provide three inverted "V" forms, approximately 10
mm 0.375 inch high, in flat surface of slide as running surface for trays.
Close ends of slide.
2.4.14.2
Tube Type
Provide four 25 mm one inch diameter 1.5 mm thick 16 gagestainless steel
tubes with supporting hardware. Close both ends of each tube.
2.4.14.3
Brackets
Stainless steel or chromium plated. Secure to counter with stainless steel
bolts. Space 1200 mm 4 feet on-center. Provide [stationary] [fold-down]
type extending under full width of tray slide.
SECTION 11400N
Page 18
Previous Page
