1.3
DELIVERY, STORAGE, AND HANDLING
Deliver hollow metal work with packaging to provide protection during
transit and job storage as recommended by the manufacturer. Door frames
shall be provided with steel spreader angles, temporarily attached to the
bottom of both jambs, one on each side of the opening to serve as a brace
during shipping and handling. Inspect hollow metal work upon delivery for
damage. Store hollow metal units on raised platforms in vertical positions
with blocking between units to allow air circulation. Keep stored material
covered and protected from damage and rust. Do not cover with plastic or
unvented canvas.
1.4
HARDWARE COORDINATION CONFERENCE
**************************************************************************
NOTE: The conference is to ensure that the
coordination takes place.
**************************************************************************
Conduct a conference for hardware and hollow metal work prior to submittals
for the purpose of coordinating the interface of materials that are
furnished by the participants listed. Require that a representative of the
entity responsible for each of the following functions attend the
conference. Notify the following participants a minimum of 5 working days
before the conference:
a.
Contractor
b.
Hollow metal supplier and installer
c.
Detention hollow metal supplier and installer
d.
Hardware supplier
e.
Hardware installer
f.
Detention hardware supplier
g.
Detention hardware installer
h.
Remote control operator and locking device supplier and installer
i.
Electrical contractor.
PART 2
PRODUCTS
2.1
MATERIALS
2.1.1
Hot-Rolled Carbon Steel
ASTM A 569/A 569M, commercial quality, 14 gage and thicker.
2.1.2
Cold-Rolled Carbon Steel
ASTM A 366/A 366M, commercial quality, stretcher level sheets, 12 gage.
2.1.3
Galvanized Steel
ASTM A 653/A 653M, CQ, mill phosphatized tested by ASTM G 60.
SECTION 11193
Page 5