**************************************************************************
USACE / NAVFAC / AFCESA
UFGS-11193 (September 1999)
------------------------------
Preparing Activity: NAVFAC
Replacing without revision
NFGS of same number and date
UNIFIED FACILITIES GUIDE SPECIFICATIONS
References are in agreement with UMRL dated 23 June 2005
**************************************************************************
SECTION 11193
DETENTION HOLLOW METAL FRAMES, DOORS, AND DOOR FRAMES
09/99
**************************************************************************
NOTE: This guide specification covers the
requirements for detention hollow frames, metal
doors and door frames for use in brigs and detention
facilities in locations where prisoners may have
access.
Comments and suggestions on this guide specification
are welcome and should be directed to the technical
proponent of the specification. A listing of
technical proponents, including their organization
designation and telephone number, is on the Internet.
Recommended changes to a UFGS should be submitted as
a Criteria Change Request (CCR).
Use of electronic communication is encouraged.
Brackets are used in the text to indicate designer
choices or locations where text must be supplied by
the designer.
**************************************************************************
**************************************************************************
NOTE: The following information shall be shown on
the project drawings:
1. Sizes of door or view window, speaking port,
louver, view port and food pass, if any, openings,
thicknesses of doors, swings, and travels of doors.
2. Indicate detention hollow metal doors as "Sec.
Holl. Mtl." or "SHM" and show that the term means
"Detention Hollow Metal Doors and Frames," in a
schedule of abbreviations.
3. The size of wall or partition where door is to
be located.
4.
Type and thickness of glazing required.
5.
Method, type, and spacing required for anchoring
SECTION 11193
Page 2
Previous Page
