drawings.
**************************************************************************
Heavy duty metal shelf shall be minimum of 18 gauge stainless steel with
hemmed edges. Shelves over 750 mm 30 inches shall be provided with
intermediate supports. Supports shall be minimum of 16 gauge, shall be
welded to the shelf, and shall be spaced no more than 750 mm 30 inches
apart.
2.2.16
Shelf, Metal, Light Duty (SMLD)
Light duty metal shelf shall be supported between brackets or on brackets.
Brackets shall prevent lateral movement of the shelf. Shelf shall be [450
mm 18 inches] [600 mm 24 inches] long. Shelf and brackets shall be
stainless steel.
2.2.17
Soap and Grab Bar Combination, Recessed (SGR)
Soap and grab bar combination shall be recessed type and shall be Type 304
stainless steel, [bright polished finish] [satin finish].
2.2.18
Towel Bar (TB)
Towel bar shall be stainless steel with a minimum thickness of 0.38 mm. .015
inch. Bar shall be minimum 19 mm 3/4 inch diameter, or 16 mm 5/8 inch
square. Finish shall be [bright polish] [satin].
2.2.19
Towel Pin (TP)
Towel pin shall have concealed wall fastenings, and a pin integral with or
permanently fastened to wall flange. Maximum projection shall be 100 mm 4
inches. Design shall be consistent with design of other accessory items.
Finish shall be [bright polish] [satin].
2.2.20
Toilet Tissue Dispenser (TTD)
Toilet tissue holder shall be [Type II - surface mounted] [Type III -
recess mounted] with two rolls of standard tissue [mounted horizontally]
[stacked vertically]. Cabinet shall be [carbon steel, bright chromium
plated finish] [stainless steel, satin finish].
2.2.21
Toilet Tissue Dispenser, Jumbo (TTDJ)
Toilet tissue dispenser shall be surface mounted with 2 rolls of jumbo
tissue. Cabinet shall be fabricated of [Type 304, 18 gauge stainless steel
with Type 304, 20 gauge stainless steel door] [high-impact plastic body and
transparent plastic front cover]. Cover shall have key lock.
2.2.22
Toothbrush and Tumbler Holder (TTH)
Toothbrush and tumbler holder shall be stainless steel, surface mounted.
Holder shall hold a minimum of four toothbrushes in a vertical position.
Size of hole for securing tumbler shall be 57 plus or minus 3 mm 2-1/4 plus
or minus 1/8 inch in diameter.
2.2.23
Waste Receptacle (WR)
**************************************************************************
NOTE: Locks are typically provided on recessed and
SECTION 10800
Page 12
Previous Page
