2.2.10
Sanitary Napkin and Tampon Dispenser (SNTD)
**************************************************************************
NOTE: Specify sanitary napkin and tampon dispensers
only when they are specifically requested, in
writing, by the Using Agency.
**************************************************************************
Sanitary napkin and tampon dispenser shall be [surface mounted] [recessed].
Dispenser, including door shall be Type 304 stainless steel and shall
dispense both napkins and tampons with a minimum capacity of 20 each.
Dispensing mechanism shall be for [complimentary] [coin] operation. Coin
mechanisms shall have minimum denominations of 10 cents, 25 cents, 50
cents, [_____] [free]. Doors shall be hung with a full-length
corrosion-resistant steel piano hinge and secured with a tumbler lock.
Keys for coin box shall be different from the door keys.
2.2.11
Shower Curtain (SC)
Shower curtain shall be [_____], size to suit conditions. Curtain shall be
anti-bacterial nylon/vinyl fabric. Color shall be [_____] [as shown in
Section 09915 COLOR SCHEDULE].
2.2.12
Shower Curtain Rods (SCR)
Shower curtain rods shall be Type 304 stainless steel 32 mm 1-1/4 inch OD
by 1.24 mm 0.049 inch minimum [straight] [bent as required] to meet
installation conditions.
2.2.13
Soap Dispenser (SD)
**************************************************************************
NOTE: Powdered soap dispenser should be included
for a shop or industrial area. Edit to meet project
requirements.
**************************************************************************
Soap dispenser shall be [surface mounted, liquid type consisting of a
vertical Type 304 stainless steel tank with holding capacity of 1.2 L 40
fluid ounces with a corrosion-resistant all-purpose valve that dispenses
liquid soaps, lotions, detergents and antiseptic soaps.] [surface mounted,
powder type constructed of stainless steel or chromium plated zinc die
casting, shall contain a swap feed mechanism and an agitator designed to
break up powdered soap, and shall have a minimum capacity of 0.94 L. 32
ounces.] [lavatory mounted, liquid type consisting of a polyethylene tank
with a minimum 0.94 L 32 fluid ounces holding capacity and a [100 mm 4 inch
] [150 mm 6 inch] spout length.]
2.2.14
Soap Holder (SH)
Soap holder shall be [surface mounted] [recessed] Type 304 stainless steel.
Separate supports shall be stainless steel.
2.2.15
Shelf, Metal, Heavy Duty (SMHD)
**************************************************************************
NOTE: Where rough usage is anticipated, shelf
support brackets and through-bolting of accessories
should be required and indicated on the project
SECTION 10800
Page 11
Previous Page
